Valley metal
Every penetration and wall joint is flashed so water stays on top of the underlayment.
Tile Roofing
Tile Roof Installation Wharton, NJ
A roofer in Wharton can install a clay or concrete tile roof, starting with a check that the framing can carry the weight and finishing with the flashing, ridge and eave details that keep it dry. One call to (862) 430-1003 reaches a nearby tile installer.
The first decision on a tile roof has nothing to do with color. Because tile is so heavy, homes converting from shingles usually need the framing checked, and some need reinforcement first. On new construction, the framing is sized for tile from the plans onward.
The tile choice comes next. Fired clay is the long lasting classic, while concrete tile is a sturdy, widely available option whose surface color softens with age. Shapes range from flat and low profile tile to high profile S tile and traditional barrel tile.
The tile may last generations, but the layers below it decide when the roof leaks. Codes typically allow tile on slopes down to 2.5 in 12, with two layers of underlayment required on slopes under 4 in 12. Investing in the underlayment up front is what lets the tile live out its full life.
Depending on what the roofer finds, tile roof installation in Wharton, NJ can go hand in hand with tile roof replacement and roof installation.
Dealing with this in Wharton, NJ right now? Call (862) 430-1003 to talk to a local roofer.
Call nowThe process
How tile roof installation works
Each layer of a tile roof has a job, and the order matters.
Plan for the load
The roofer confirms the framing can carry the tile, often with an engineer when a home is switching from shingles, and pulls the permit the job needs. Extra tile is ordered so there are matching spares for repairs later.
Dry in the roof
Decking is checked and fastened, drip edge goes on, and the deck is covered with the chosen underlayment, with self-adhered membrane in valleys and at eaves where ice or wind-driven rain is a concern. The underlayment is the true waterproof layer, so this step deserves the most care.
Install battens
Battens run horizontally to hold each course of tile, often raised on counter battens to leave a drainage and air space below. That air space under the tile helps the roof shed heat and dry out.
Flash the details
Wide valley metal, pan flashing at walls and soft metal flashing at pipes are installed so water is carried over the underlayment, not into it. Tile flashing has to reach up and over curved profiles, so it is larger than shingle flashing.
Fasten each course
Tile goes on from the eave up, with an eave closure to keep birds out and fasteners or foam adhesive chosen for local wind requirements. Small cut pieces at hips and valleys get extra attention.
Finish the ridge
Hips and ridges are capped, often with a mechanically fastened system that allows ridge ventilation. The roof is cleaned, broken pieces are replaced and spares are left with the owner.
What is included
What tile roof installation includes
Load check
The framing is checked for the weight of tile so the roof does not sag over time.
Waterproof layer
Doubled or self-adhered underlayment goes down where needed lapped to shed water to the eaves.
Tile attachment
Each tile is secured to the deck or battens in a pattern set by the tile profile.
Ridge finish
Eave and ridge details are finished so birds and wind-driven rain stay out.
Related service
Barrel Tile Roof Installation Wharton, NJ
A barrel tile roof uses two pieces per course, a pan tile that channels water and a curved cover tile that caps each seam. Their tapered shape and deep profile create the rolling texture that defines the style. Because of that depth, barrel tile needs careful work at the eaves, hips and ridges, where the open curves must be closed off.
Barrel tile roof installation in Wharton calls for extra attention to fastening, since cover tiles sit high and catch wind. Pans and covers have to run in straight lines with even exposure, which takes careful layout before the first pan goes down.
Related service
Spanish Tile Roof Installation Wharton, NJ
Spanish tile, also called S tile, merges the curved pan and cover into one interlocking piece. It comes in clay and in concrete, with colors from terracotta to multi-tone blends. Its interlocking side laps shed water well, but the curved ends at eaves and ridges still need closing off.
A Spanish tile roof on a Wharton home starts with the same foundation as any tile roof: sound framing and a solid underlayment. The curves make flashing tricky, so roofers use shaped metal or flexible flashing that conforms to the tile. If you choose a blend, the roofer mixes tile from several pallets at once to spread the color evenly.
Local help
Tile Roof Installation Near Me
In Wharton, new tile roofs go onto homes of every age, from fresh builds to older houses moving away from shingles. For older homes in Wharton and nearby towns like Dover, Rockaway, Mount Arlington and Landing, the framing check is the step that decides whether tile is practical, while homes already built for tile can usually go straight to choosing a profile and color.
Searching for tile roof installation near me from Wharton or Dover, Rockaway, Mount Arlington and Landing? Call (862) 430-1003 to talk to a roofer who works in your part of town.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Wharton, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why act early
Less damage
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Familiar with local homes
Roofers in Wharton know the roof types and weather wear common in local homes.
Know what happens next
Ask your questions before you agree to anything.
Tile Roof Installation FAQ
What is better, clay or concrete tile?
The choice comes down to priorities. Clay tile resists fading and has lasted a century or more on some older buildings. Concrete is sturdy and widely available, though it absorbs more moisture and its surface weathers with age.
How long does tile roof installation take?
Expect more time than a shingle job, since each tile is placed and fastened by hand over more layers. Steep pitches, many hips and valleys and a structural upgrade all add time. Once the underlayment is down, the house is protected from rain while tile goes on.
Can my house hold a tile roof?
Clay and concrete tile are among the heaviest roof coverings, several times the weight of shingles. Homes built for tile carry it fine, but a house framed for shingles may need an engineer to check the rafters or trusses and add reinforcement. Lightweight concrete tile is an option for some homes that fall short of the load for standard tile.
Can tile be installed over an existing roof?
The old roofing is torn off before tile is installed. Removing the old roof also takes weight off the framing, which matters with a material this heavy.
What underlayment goes under a tile roof?
Tile roofs use heavy felt, synthetic underlayment or self-adhered membrane, sometimes in two layers. Since the tile can outlast the underlayment by decades, a longer lasting underlayment pays off. On slopes below 4 in 12, code requires two layers.
More questions? Call (862) 430-1003
Other services that may help
Tile Roof Replacement
Replacing a worn tile roof, either by relaying the existing tile over new underlayment or by switching to new tile, done slope by slope to keep the house protected.
Learn moreRoof Installation
New roof installation done in the right order with the right details, with ventilation and flashing planned in from the start.
Learn moreTile Roof Inspection
Tile roof inspections that count broken and slipped tiles, check the layers beneath and estimate how much life is left, before buying a home, after a storm or as the underlayment ages.
Learn moreRoof Ventilation
Fixing hot, damp or poorly vented attics with the right mix of intake and exhaust, so shingles and decking last as long as they should.
Learn more
Looking for something else?
See all roofing servicesNeed tile roof installation in Wharton, NJ?
Call (862) 430-1003 for a local roofer in Wharton and nearby towns.