New trim
Matching flashing at every edge instead of reusing old pieces.
Metal Roofing
Metal Roof Replacement Wharton, NJ
A Wharton roofer can tear off an old metal roof, re-cover it with new metal or replace a shingle roof with metal, after checking the framing and decking underneath. One call to (862) 430-1003 reaches a nearby roofer who replaces metal roofs.
A metal roof needs replacing when the metal itself is failing, not just the screws. When panels are perforated by rust, the finish is gone and every screw hole has been enlarged by years of movement, repairs stop keeping up. Older galvanized roofs with little coating left are the common candidates.
Not every metal roof replacement starts with a tear-off. A full tear-off removes the old panels and trim so the purlins or deck can be inspected and repaired, then new metal goes on. In a retrofit, new panels go over the old roof on a framing system, avoiding tear-off on large or occupied buildings.
A big share of metal replacement work is switching a worn shingle roof to metal. Depending on code and deck condition, the old shingles are either removed or covered. It helps to know what is on the roof now, how old it is and whether it has ever been covered over.
Metal Roof Replacement is often paired with metal roof installation and metal roof repair, depending on the cause.
Need metal roof replacement in Wharton? Call (862) 430-1003 to reach a nearby roofing contractor.
Call nowThe process
The metal roof replacement process
The order of work depends on tear-off or re-cover, but the basics are the same.
Assess the old roof
The old roof and the structure beneath it are evaluated for rust, rot and fastener holding power. It also tells whether the framing needs work first.
Plan the new roof
The new system is selected, whether exposed fastener or standing seam, and the method of replacement is settled. Switching to standing seam usually means adding solid decking.
Tear off
Old panels, trim and fasteners are removed and sorted for scrap metal recycling. Only as much roof is opened as can be covered the same workday.
Restore the deck
Framing and sheathing damaged by old leaks are replaced before new metal goes on. This step is skipped on a re-cover, which is why the structure is checked first.
Install the new metal
The roof is dried in, trimmed and paneled, with new boots and flashing at every penetration. Gutters may be reset to match the new eave line.
What is included
What metal roof replacement includes
New panels
Fresh metal cut to length for each slope replace the old roof.
Tear-off
Old metal panels, trim and fasteners are removed section by section.
Deck repair
Damaged structure is repaired so fasteners hold.
Re-cover option
Where suitable, new metal goes over the old roof on sub-framing on larger buildings.
Related service
Metal Roof Panel Replacement Wharton, NJ
Metal roof panel replacement swaps out individual damaged panels instead of the whole roof. On exposed fastener roofs, the roofer removes the screws on the damaged panel and the overlapping edges of its neighbors, slides it out and sets a new one in sealant. Concealed fastener panels take more time to replace because of the seams.
On a Wharton roof that is otherwise sound, a few new panels can add years of service. Expect a slight color difference between new and old metal. Once a large share of panels need work, replacement becomes the better plan.
Related service
Metal Roof Over Shingles Wharton, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Where code permits, the roofer adds underlayment or furring strips over the shingles and fastens the metal through to the deck.
The tradeoff is that nobody sees the deck. Before going over shingles on a Wharton home, the deck is checked from inside and any soft areas are found. If the deck is questionable or there are already two layers, a tear-off is the better choice.
Local help
Metal Roof Replacement Near Me
In Wharton, many metal replacements are older galvanized roofs that have finally rusted through. Across Wharton and nearby communities including Dover, Rockaway, Mount Arlington and Landing, metal roofs that went decades without fastener work are the usual replacement jobs, which is why the condition of the purlins and deck drives the plan.
Searching for metal roof replacement near me from Wharton or Dover, Rockaway, Mount Arlington and Landing? Call (862) 430-1003 to talk to a roofer who works in your part of town.
How the weather here affects roofs around Wharton
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Wharton is busiest after a hard winter and before the next one.
Why call
Why not wait
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers who know Wharton
Roofers in Wharton know the roof types and weather wear common in local homes.
Straight answers
Ask the roofer about the cause, the options and the estimate before work starts.
Metal Roof Replacement FAQ
How do I know my metal roof is past repair?
The tipping point comes when rust or wear is spread across the roof, not just in a few spots. Widespread rust-through, failed paint and stripped holes everywhere usually mean new metal. A call to (862) 430-1003 is a good way to find out where the roof stands.
Can a metal roof be installed over shingles?
Local code decides whether metal can go over existing shingles. It saves tear-off and disposal, but it hides the deck, so the attic should be checked for rot and soft spots first. If the deck is questionable or there are two layers already, a tear-off is the better route.
What is a metal roof retrofit?
A retrofit, or re-cover, installs new metal over the existing panels using a sub-framing system. The method is popular on commercial buildings and large outbuildings. The framing must be sound enough to support both layers.
Can I replace just one damaged metal panel?
Single panel replacement is common on exposed fastener roofs. A new panel of matching profile and gauge goes in with fresh sealant and screws. New panels may look brighter than the old ones at first.
Is old metal roofing recycled?
Metal roofing is one of the most recyclable building materials. Unlike shingles, which usually go to a landfill, metal is sorted and sent for recycling. Ask the roofer how disposal is handled before work starts.
More questions? Call (862) 430-1003
Related services
Metal Roof Installation
New metal roofs in standing seam, exposed fastener, metal shingle and stone coated steel, with high-temperature underlayment and proper flashing.
Learn moreMetal Roof Repair
Replacing worn screws and washers, resealing panel laps, treating rust and fixing loose trim on metal roofs, so the panels keep shedding water for years more.
Learn moreRoof Replacement
Full tear-off and replacement for roofs that are worn out, storm beaten or leaking in several places, with the old layers removed and the deck checked.
Learn moreStanding Seam Metal Roof
Standing seam metal roofing installed, repaired and detailed for thermal movement, built to let the metal move without leaking.
Learn more
Looking for something else?
See all roofing servicesGet metal roof replacement help in Wharton
Call (862) 430-1003 to talk to a roofer serving Wharton, NJ.